Recommended for clarification, purification and sterilisation of aqueous solutions and/or biological samples.
- Surfactant-free Cellulose Acetate membrane, in Polypropylene housing
- Hydrophilic, high flow rates
- Low adsorption: 0.8 – 3 µg/cm2 with BSA, 8 – 12 µg/cm2 with gamma globulin
- Burst pressure: 6 bar
- Low hold-up volume: <65 µl
- Female luer lock inlet; male Luer slip outlet
Recommend for HPLC and GC samples, sterilisation and clarification of most solvents and filtration of gases-venting.
- PTFE (Teflon) membrane, in polypropylene housing
- Hydrophobic, very high flow rate
- Burst pressure: 6 bar
- High chemical resistance to most solvents and acids
- Low hold-up volume: <25 µl (15 mm), <65 µl (25 mm)
- Female luer lock inlet; male luer slip outlet
Recommended for analytical applications, filtration of samples and solvents for HPLC, under non-extreme conditions.
- Nylon membrane (Polyamid), hydrophil, in polypropylene housing
- Compatible with dilute organic solvents (such as acetone, methylene chloride and acetonitrile)
- Do not contain wetting agents
- Burst pressure: 6 bar
- Low hold-up volume: <65 µl
- Female luer lock inlet; male Luer lock outlet
High resistance in filtration and sterilisation of aqueous and organic samples in HPLC applications.
- Regenerated cellulose membrane in polypropylene housing
- Hydrophilic, high flow rate
- Resistant to almost all solvents and aqueous solutions in pH range 3 – 12
- Low protein adsorption: <10 µg/cm2 with BSA
- Burst presseure: 6 bar
- Low hold-up volumen: 25 µl (15 mm), 65 µl (25 mm)
- Female luer lock inlet; male luer slip outlet
